Trouble-Shooting Guide
(valid for all ?LCD Intelligent Dialogue WAL.....? models)
Depending on the model, your ? The water in the inlet hose is The washing machine
washing machine is equipped frozen;vibrates during the spin
with various automatic safety ? The washing machine has a cycle.
functions. This enables faults to safety hose and the safety Check whether:
be detected in good time and the valve is open (red indicator in ? The washing machine is
safety system can react the safety valve inspection standing horizontal and even
appropriately.window); In this case replace it on all four feet (see
These faults are frequently so with a new safety hose.?Installation/Adjust the feet?);
minor that they can be removed Reconnect the appliance to the ? The transport bolts have been
within a few minutes.electrical socket. Switch the removed. The transport bolts
washing machine on and restart
The appliance will not start, must be removed before using
the desired programme (do not
no display is visible.the washing machine (see
Check whether:add any more detergent).?Installation/Remove the transit
? The mains plug is inserted into The washing machine stops bolts?).
during the programme and
the socket;Final spin results are poor:
the ?Start? light flashes.
? The wall socket is functioning Check whether the notice ?Load
correctly (use a table lamp or Check whether:Imbalance? or ?Overdosing?
? ?Rinse Hold Selected? appears
similar to test).appears on the display.
in the display. The washing machine has an
? The ?On/Off? button has been
? The door has been opened.imbalance detection and
pressed and the washing Close the door.correction system. If individual
machine is switched on.
Press the ?Start? button to heavy items are loaded (a
The washing machine will
continue with the programme.bathmat, bathrobe), this system
not start and the ?Start?
light is flashing.Detergent and additive may reduce the spin speed
product residues in automatically or even interrupt
An acoustic signal sounds and the
dispenser at end of wash.the spin completely if it detects
notice ?Door Open!? appears in
Check whether:too great an imbalance even
the display:? The siphon is correctly installed after several spin starts, in order
? Close the door (child safety).and clean (see ?Care and to protect the washing machine.
The washing machine stops Maintenance?);? If the laundry is still too wet at
shortly after the ? Enough water is being the end of the cycle, add smaller
programme start.supplied. The mesh filters articles of laundry and repeat
An acoustic signal sounds and the could be clogged (see ?Care the spin cycle.
and Maintenance/Mesh filter ? Excessive foam formation may
notice ?No Water Supply?
appears in the display.in the water connection?).prevent spinning. Observe
Switch the washing machine off, ? When using powder detergent correct detergent dosing.
beforehand, the coloured Check whether:
pull out the mains plug and
insert for dosing liquid ? Spin speed ?0? has been
check whether:
? The tap is fully turned on;detergent has been removed selected.
from the dispenser .
? The water supply pressure is
sufficient;
? The water supply hose is
kinked;
? The mesh filters are blocked
(see ?Care and Maintenance/
Mesh filter in the water
connection?);
38 |